Technical Specifications:
The system contain the following components :
- 3 pieces of: Single crystalline Solar modules
each of 75 Wp. The solar modules are designed to
meet or exceed the environmental requirements.
Solar charge controller:
The charge controller is
a 12 Volt, 20
Amp solar charge and 20 Amp consume output, ensure overcharge
and low voltage protection.
The controller has the following performance: solar module inputs.
load outputs with a 20 Amp fuse. LED indications of charging,
blown fuse and battery voltage. Protected against, low voltage
discharge, battery overcharge and load short-circuit.
Module structure:
3 pieces module support structure type HEM-75H, designed for
mounting of 3 modules. The structure is
made of strong aluminum capable of high withstanding wind speeds.
Variable leg length gives rise to an adjustable tilt angle.
The structure is equipped with necessary nuts and bolts of stainless
steel.
Battery pack:
Consisting of 3 pieces High quality Sealed, maintenance-free
Gel battery with 800 cykles life, type DSGELL90, 90Ah/12 Volt.
Total battery capacity 270A/h
- 16 metres of cable 2x6 m2 for inter module cabling.
- 1 piece of safe packing and transport of the equipment.
- 2 cables for Parallel mounting of the batteries.
- Complete installation pack
Accessories/Spare parts/Consumable:
The following accessories can be bought separately:
- DSGEL90 High quality Sealed gel-cell batteries, 90Ah/12V.
- Solar panels
- Complete installation pack
Weight/Volume:
- estimated weight: 119 kg
Shipping details:
Batteries are approved for airfreight. However, due to weight,
sea-freight is recommended unless for emergency delivery/use.
Instructions for use:
3 panels are mounted electrically in parallel and secured to
the
aluminum support structure. Panels are installed on rooftop,
or other
suitable and secure location with direct view of the sun. Support
structure elevation is adjusted for maximum (geographical and
day-round) solar power.
Cable run from panels to the charge regulator and from the charge
regulator to the battery, load run from the charge regulator
The panels should be cleaned (water/soft brush) at regular
intervals to
assure maximum effect.
print page |
